Step 2: Choose the bath tissue dispenser that most closely resembles your current dispenser

Your current dispenser
Your Tork upgrade
2-roll-drop-down.png
2-Roll Drop Down
Identifying features:
These can have a flat or a curved cover. There are also versions that are recessed (cut) into the wall. But the mechanism is the same. The spindle will automatically drop down from the upper (reserve) position when there are only a few sheets of tissue remaining on the bottom refill.
cast-aluminum---surface-mounted.png
Cast Aluminum – Surface-Mounted
Identifying features:
These are available in single or double roll versions. The spindles are oval shaped. Some of these are “controlled delivery” where there is a small pin that protrudes from both of the aluminum “arms” which stops the spindle from rotating a full 360 degrees. If the dispenser has thesetheft-resistant pins on them, the adapter will not work.
multi-function-partition-mounted.png
Multi-Function, Partition Mounted
Identifying features:
These are large units that can be either cut into a toilet partition (the panel dividing two toilet stalls), or cut directly into the wall. They may have a napkin disposal unit and toilet seat cover dispenser but will always have two rolls to service one toilet stall. There are also somepartition-mounted units that contain just bath tissue, with two rolls on either side, to service two toilet stalls. The spindles in these units may have been changed from a standard spring-loaded spindle to a theft-resistant spindle that requires a key to loosen.
recessed-1-or-2-roll-with-hood.png
Recessed 1- or 2-Roll
Identifying features:
These dispensers are recessed (cut) directly into the wall and are available in single or 2-roll side-by-side. They have a simple round, spring-loaded spindle.
recessed-1-or-2-roll-with-hood.png
Recessed 1- or 2-Roll with Hood
Identifying features:
These dispensers are recessed (cut) directly into the wall. They are available in single or 2-roll side-by-side. They have a simple round, spring-loaded spindle and a protective hood that covers the top of the toilet roll.
surface-mount-2-roll-with-shelf.png
Surface-Mount 2-Roll with Shelf
Identifying features:
This type of dispenser has a shelf on top and two side-by-side rolls. They are held in place by simple, spring-loaded spindles.
surface-mount-1-or-2-roll.png
Surface-Mount 1- or 2-Roll
Identifying features:
These dispensers are recessed (cut) directly into the wall and are available in single or 2-roll side-by-side. They have a simple round, spring-loaded spindle.